 |
Motion Simulator community
|
LCD display question
- on 22.01.2012, 02:36
LCD display question
by eloverphx on 22.01.2012, 02:36
So finally got my AMC board programmed and running. I got a cheap potentiometer for my first pot and the two number on the top right of the screen never stop bouncing until it goes up to 1023. Then one the bottom side of it, it never zeros out. Is that ok or do I need better more accurate pots?
- eloverphx
- full member
- Posts: 35
- Joined: 14.12.2011, 07:48
- Location:
Phoenix, Arizona, USA - Local time: 21.05.2013, 09:57
- Obtained thanks: 0 time
- 1 post • Page 1 of 1
Similar topics
| Triple Screen Fresnel Lens Display for $220 | Forum: DIY peripherals | Author: Turn | Replies: 5 |
| Quick question from a newcomer | Forum: New users start here - FAQ | Author: MikeyTT | Replies: 1 |
| Question on extracting yaw data from MS flight simulator'04 | Forum: X-Simulator Q&A/FAQs | Author: Luisteo | Replies: 2 |
| Pololu question | Forum: DIY motion simulator building Q&A/FAQ | Author: killibacak | Replies: 8 |
| Seat mover design question. | Forum: DIY motion simulator projects | Author: boss.mann71 | Replies: 3 |
Return to X-Simulator compatible hardware
Add this Thread to:
Who is online
Users browsing this forum: No registered users and 0 guests
SitemapIndex
RSS FeedImpressum - legal notice | Author: Rene Hermenau
Looking for a qrcode generator? My personal recommendation creates very high-resolution and color qr codes within seconds. It also helps to make a design qr code. Here you find the qr code generator.