Motion Simulator community for haptic flight and racing simulation. Get in and start your project: Register here

[bsft]

Seat Mover Motion Simulator for PC only $1100





This seat mover is designed to run from 12volts and uses x-sim software, from
http://www.x-sim.de , you will need to register, as the software is free.
The software currently supports the following games,

Codemasters F1 2010 and 2011
* RFactor
* ARCA
* Live for Speed
* GTR
* GTR 2
* Race
* Race 07
* GT Legends
* GTR Evolution
* Nascar Racing 2003
* Nascar Racing 2005
* Collin McRay Dirt
* Dirt 2 and 3
* Racedriver Grid
* Racer (Freeware)
* Grandprix 3+4
* IRacing
* Cruden Racer

More games will be added by the program developers in time.

The seat mover uses 2 x Pololu JRK 12v12 control boards , 2 x high out put 12 volt motors, it has a single turn potentiometer on each motor setup as feedback.
The frame is of new 25x25x1.6mm steel that is welded and bolted together. The new MDF sheet is for the mounting of the motors and the pivot point of the seat.
The seat is second hand, but in good condition and will suit a driver up to 95kg. A bigger seat would be needed if a larger driver is using the simulator.
The control boards and motors have had about 3 hours use only on them.
Videos of motion.
http://www.youtube.com/watch?v=H9_e3NQrIso
http://www.youtube.com/watch?v=Syda-VyAQTk


You will need a decent gaming PC with at least 3 USB ports available.
The boards are easy to set up in the JRK utility program and the x-sim software.
The prospective buyer will be trained up to operate the simulator and software.

The MDF wheel and pedal frame is free and you can have it, or even fit it to an existing static racing frame. Even give it a paint to the colour you like.

Any inquires can be forwarded to me via email at ziltoid@optusnet.com.au
Sydney metro and outer areas only.