Motion Simulator community for haptic flight and racing simulation. Get in and start your project: Register here

[ElektronikJack]

I use this profiles with SimforceGT Simulator with wiper motors:
elektronikjacks-simulator-t717.html

Profiler:


G-Effekt 24


G-Effekt26


G-Effekt27 (Rumble ..curbs..)


USO Config:


have fun

[egoexpress]

Hey Dirk,

Bzw, eine Profiler savedatei für RFactor wäre noch besser (also die .rnr Datei).

Gruss
Christian

[rafael_design]

where can I find motion profiles for simforce + wipermotors? regards!

[Nima]

hi you can load a scn5 profil with only math dialog.than you must set the axis in uso

[rafael_design]

Hi Nima! Thanks!
But I could not have success.
When I open a SCN5 profile it have two actuators.
I dont know how to transform the left/right actuators to x/y axis, that work for me.
I understand that you said to configure USO, but how?
I tried for several hours to figure it out without success.

If someone could post one simple example would be awesome!

regards!

[rafael_design]

Here is the profile that work for me:

RafBRprofile2 ok.rn2

(5.59 KiB) Downloaded 131 times

Can you edit the USO configuration and send it back to me?

[Nima]

hi
i dont now were i can change it in the uso but i have translate a rfactor profil from my to x any y axis
is with slider the slider on the top are for left right effects the other for for and behind.

[rafael_design]

Thanks!
Is this profile based on SCN5? Or it is for wipermotor from scratch?
I ask because you said that we can use SCN5 profiles and I am curious about that. Some of the SCN5 profiles i've seen seem so complex, it must worth the try!
here the video of my Sim so far:
http://www.youtube.com/watch?v=kqpKtW_46mw
In this video I just use 4 forces:
accelerate/brake, side forces, vertical and gear change.
regards!

[Nima]

hi
the profil is make on scn6 i have set the y value on the x axis to zero and delite the slider.
the same with the x values on y axis.

[bsft]

Thanks!
Is this profile based on SCN5? Or it is for wipermotor from scratch?
I ask because you said that we can use SCN5 profiles and I am curious about that. Some of the SCN5 profiles i've seen seem so complex, it must worth the try!
here the video of my Sim so far:
http://www.youtube.com/watch?v=kqpKtW_46mw
In this video I just use 4 forces:
accelerate/brake, side forces, vertical and gear change.
regards!

The motion looks good, perhaps on the body roll - lateral force effect, you could try increasing this number to give you more gradual roll, so when you turn a bit the frame rolls a bit. Like when you go around a long sweeping bend, you are not turning that hard but still want a bit of car body roll. Just a though.